Metallic holder with drip tray to be installed on polyethylene tanks of 1.000 litres with metal tubular framework for all type of assemblies and pumping kits. It is also available made of galvanized steel.

(Size: 170x1.105x605 mm)

Handle with lower support to be fitted to gear pumps for an easy handling. It is available in black colour.

Metallic nozzle holder with drip tray.

(Size: 150x150x600 mm)

Swinging zinc-plated wall bracket to move the hose-reel where you want.

Zinc-plated support to install the pneumatic pumps on the wall.

Galvanized sheet support to quickly fix all the pumping kits in the polypropylene tanks "with metallic framework" of 1.000 litres and double wall steel tanks.

It also can be fixed on the wall. It is supplied with 4 Ø8x50 mm metallic stoppers.

It has a nozzle holder with rubber protection and a drip plate.

Metallic holder with drip tray to hang 2 nozzles and the probecarrier tubes. It can be fixed on the wall or on the ground.

(Size: 300x100x1.200 mm)

Support to hang the hose. It is adaptable to all type of barrels and tanks.

Special support to fix pneumatic pumps and/or hose-reels (up to 4 units) at any point of the workshop or operation zone to simplify the installation. It can be fixed on the ground or on the wall through 2 vertical brackets.

It is specially suitable for the cased and/or open hose-reels battery installations in automotive workshops and industry, where it is not suitable to install hose-reels on the wall or ceiling. It makes easier the service in the nearest site to the vehicles. It allows the installation of 3 or 6 hose-reels in battery.
It is supplied with a drip tray.

Size: 1.100x350x2.100 mm

Size: 2.300x500x2.100 mm